The heating is on, the boiler is running, but one radiator stays stubbornly cold — or only warms up halfway. Where the cold patch is tells you a lot about the cause. Here is a quick guide for Maidstone homeowners, including how to bleed a radiator properly.
Cold at the top, warm at the bottom
That is trapped air, and it is the easiest fix. Air collects at the highest point of the radiator and stops hot water filling it. Bleeding the radiator lets the air out.
How to bleed a radiator
- Turn the heating off and let the radiators cool. Hot water can spit out of the valve.
- Find the bleed valve at the top corner of the radiator. You will need a radiator key (from any hardware shop) or, on some valves, a flat screwdriver.
- Hold a cloth under the valve and turn the key anticlockwise about a quarter turn. You will hear air hissing.
- As soon as water starts to come out, close the valve again.
- Repeat on any other radiators that need it, then check the boiler pressure. Bleeding lets water out of the system, so you may need to top it up — see our guide to low boiler pressure.
Cold at the bottom, warm at the top
That usually points to sludge — a build-up of rust and debris that settles in the bottom of the radiator. Bleeding will not fix it. On older systems where several radiators are affected, a power flush cleans the whole system and helps the boiler work less hard.
Cold all over
If the whole radiator is cold, check that the valves are open and the thermostatic valve (TRV) is turned up. TRV pins can stick after a summer off — that is a common cause. If radiators near the boiler get hot while those further away stay lukewarm, the system may need balancing so the hot water is shared out evenly.
When to call us
If radiators keep needing bleeding, that is a sign air is getting into the system — worth getting checked. The same goes for sludge, stuck valves and uneven heating across the house. PlumbStar looks after central heating in Maidstone and the surrounding Kent area. Call or WhatsApp 07404 190719.



